Construction Tips: Installing Plywood Flooring the Right Way

Plywood is simply a combination of many layers of wood all bonded together. That's where it gets its strength. This material has got a number of applications, and one of the major ones is flooring. Using plywood as flooring has got many benefits. It's cheap, looks amazing and saves a lot of time. It's also very easy to install the flooring, so you can even DIY. However, before going for the leap, you need to be aware of a number of things. Using plywood needs caution. Install it poorly, and you'll be replacing it sooner than planned. If you're looking to install plywood flooring, then here are some things to consider.

Plan Your Plywood Pieces

The first step is to ensure that you properly plan ahead so that you don't make so many cuts. The thing is, plywood only comes in specific sized sheets. You can simply calculate the total floor area and then divide it by the plywood sheet area. Add a few extra sheets just in case.

You also need to ensure that most of the cut sides are against the room's perimeter to prevent them from being easily spotted. The cut edges won't be as clean as the factory edges so placing them against the walls would keep the rest of the floor uniform.

With plywood, you don't even have to get rid of your old flooring. Simply clean up the floor and scrub out the dirt, and then you'll be ready to install the plywood flooring on top of it.

You also need to get subfloor plywood because they are better suited for flooring. Their edges have a tongue and groove configuration that increases support when they are installed.

Leave Some Allowance

The multiple number of sheets that you'll need will leave lines on your floors. They can look quite appealing when uniform so to ensure that they are consistent, you can place a coin between them during your installation. Apart from keeping the floor looking elegant, leaving uniform gaps will allow room for expansion and slight movement. Also leave some room between the flooring and walls to allow for swelling and expansion.

Finishing the Flooring

Leaving the flooring without any finish would make it easily susceptible to damage. You can apply multiple coats of floor grade polyurethane to ensure that the plywood is properly sealed and resistant to moisture. When doing so, get rid of dust after each layer by using a damp towel and gently wiping it away. You could also sand the surface lightly between each coat if you're looking for that extra smooth finish.


Share